Produits
Retour
Fabricants
Retour
Ressources
Retour
Retour
Retour
- Programmes & services
- Programme académique
- Automatisation et contrôle
- Services de conception et d'intégration
- Solutions numériques
- Solutions IoT
- Traçage des pièces
- Services de produits
Retour
- Acheter
- Outils
- myLists
- Devis
- Produits
- Fabricants
Traçage des pièces

TechForum

Webinars

Scheme It
Demander un devis

EV1406-1800-A(#4): 1V @ 6A, 12V in

Summary

* This RDL design page & User Guide are based on this board being programmed to 1V

The EV1406-1800-A facilitates the evaluation of the FS1406 µPOL® module. This board generates an output voltage of 0.6 ~ 2.5V for loads of 0 ~ 6A from an input voltage of 12V.

The TDK I²C uPOL programming dongle 445-TDKMICRO-POLDONGLE-ND is able to interface with the uPOL and with the use of the TDK programming GUI, able to set and program features of the FS1406 with output voltages and current able to be adjusted down to 0.6V of output voltage and 500mA of output current.

Specifications

Manufacturer	TDK
Category	AC/DC and DC/DC Conversion
Sub-Category	DC/DC SMPS - Single Output
Eval Board Part Number	445-EV1406-1800-A-ND
Eval Board Supplier	TDK
Eval Board	Normally In Stock
Topology	Step Down
Outputs and Type	1 Non-Isolated
Voltage Out: Factory Set	1 V
Current Out	6 A
Voltage In	4.5 ~ 16 V
Efficiency @ Conditions	>81%, 12V in, 1V @ 2 ~ 6 A
Voltage Out Range	0.6 ~ 2.5 V
Features	GUI / Design Software I²C Interface Internal Inductor LDO Regulator(s), On-Chip Low Profile, ~1.5mm Noise Filtering, On-Chip Over Current Protection Over Voltage Protection PFM or PWM Pre-Biased Startup Shoot-Through Protection (Overlap) Shutdown, Enable, Standby Soft Start Temperature Compensation Thermal Protection Under Voltage Protection, Brown-Out
Switching Frequency	1 MHz
Standby Current [Typical]	1 mA
Quiescent Current [Typical]	19 mA
Component Count + Extras	15 + 22
Internal Switch	Yes
Design Author	TDK Corporation
Application / Target Market	Distributed Power Systems FPGA / DSP / Processors Point of Load (PoL) RF: Metering
Standby Current [Maximum]	- Not Given
Quiescent Current [Maximum]	25 mA
Main I.C. Base Part	FS1406
Date Created By Author	2019-05
Date Added To Library	2021-01