Settings
Fast Delivery
Free Shipping
Incoterms
Payment Types
Marketplace Product
Slide 1
Slide 2
Slide 3
Slide 4
Slide 5
Slide 6
Slide 7
Slide 8
Slide 9
Slide 10
Slide 11
Slide 12
Slide 13
Slide 14
Slide 15
Slide 16
Slide 17
Slide 18
Slide 19
Slide 20
Slide 21
Slide 22
Slide 23
Slide 24
Slide 25
Slide 26
Slide 27
Slide 28
Slide 29
Slide 30
Product List
The layout of components in the hot swap loop is critical to correct operation, good accuracy, and thermal efficiency. If using a 4-pin sense resistor, then the layout is simple enough as the sense lines are already defined. However, in most cases a simple 2-pad sense resistor will be used. In this case it is very important that the correct points on the pad are used for sensing the voltage drop. Kelvin sense lines are recommended from the center of the resistor footprint. Additionally, the Sense Resistor should not be placed too close to heat sources like the MOSFET as a temperature rise may lead to inaccuracies due to resistor TC.
PTM Published on: 2008-04-29
France